Qlima HEATOR SRE 1528 C-2 Manuel D'utilisation page 75

P
Q
R
Fuel filter
S
T
E remove the removable tank from the heater and fill it with new fuel (outside
the living space in a safe place) (see chapter B)
If you take no action, the fuel tank will be emptied and the display will indicate
"E 03" (fig. Q). The heater is automatically turned off.
To ignite the heater once more, fill the tank and wait a few minutes.
Then press the ON / OFF button
K
CHECKING THE AIR QUALITY
If the space is insufficiently ventilated, the indicator E17 will light up and the
heater is automatically turned off. As soon as you hear this signal, ventilate
the space (e.g. by opening a door or a window). As soon as the space has been
ventilated sufficiently, (e.g. by opening a door or a window) the heater can be
ignited by pressing the ON/OFF button
L
MAINTENANCE
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance.
1 Clean the ventilator filter (fig. R).
Clean the fuel filter:
1 Remove the removable tank 4 from the heater and remove the fuel filter
(Fig. S). Some drops may leak from the filter; keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-down against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
Do not use solvents or alcohol to clean the heater: fire hazard.
Clean very dirty components with a light synthetic cleaning agent.
Do not remove any heater components yourself. Always contact your dealer for
repairs.
When the power cord is damaged, it may only be replaced by an authorised
fitter. Use a new cord of the type H05 VV-F.
.
20
.
20
4
73