Velleman Perel BG90017 Mode D'emploi page 5

6.3 Setting/Changing the Personal Code
1. With the door open, press the reset button.
2. When the yellow LED burns, enter a personal code (3 to 8 digits) and press the confirming
button (#). The two beeps mean that your code has been validated.
Please re-enter your code and confirm if the yellow LED flashes and the safe beeps three
times.
3. Proceed with programming the manager code.
6.4 Setting/Changing the Master Code
1. With the door open, press 0 (zero) twice and press the reset button.
2. When the yellow LED burns, enter a master code (3 to 8 digits) and press the confirming
button (#). The two beeps mean that your code has been validated.
Please re-enter your code and confirm if the yellow LED flashes and the safe beeps three
times.
6.5 Closing the Door
Close the door and turn the master lock to the left.
6.6 Opening the Door
1. Enter your personal code and press the confirming button (#).
2. As soon as the green LED burns, turn the master lock to the right and pull the door open.
Please retry if the yellow LED flashes and the safe beeps three times.
6.7 Auto Lock
The safe will disable the keypad automatically for 20 seconds after three erroneous code
entries.
After three more erroneous code entries, the keypad will be locked for 4 minutes and
30 seconds.
Disabling the alarm can only be done by opening the safe with the override key and removing
the batteries.
V. 01 – 20/06/2018
BG90017/BG90018/BG90019/BG90020
5 ©Velleman nv