Connecting Euroblock Plugs (Mm-4D/In-E Only) - Tascam MM-4D/IN-E Mode D'emploi

External control connectors
9
(LED/SWITCH, MM-4D/IN-E only)
LED
connectors: These are open collector mute status
output connectors.
SWITCH
connectors: These are control input connec-
tors. These mute the audio signals
from the analog input connectors.
These can also be used by operat-
ing (short/open) a switch connect-
ed between the
connectors.
GND
connectors: These are grounds for the control con-
nectors.
Gigabit link status indicator
0
Orange indicates that a gigabit Ethernet link has been
established.
Link status/activity indicator
q
Green indicates that a link is established between the
devices.
Blinking indicates that signals are being transmitted be-
tween the devices.
DC IN 12V connector
w
Connect a PS-P1220E AC adapter (sold separately) here.
Cord holder
e
When using a PS-P1220E AC adapter (sold separately),
hook its cord here to prevent accidental disconnection.
Connecting Euroblock plugs
(MM-4D/IN-E only)
SWITCH GND
and
Euroblock plug tab
1.
NOTE
Use a flat-blade screwdriver with a width of 2.5mm or
less.
2.
NOTE
AWG16–AWG28 wires are compatible with the includ-
ed Euroblock plugs. Using wires within the compatible
range, trim about 7 mm of the protective sheaths from
their ends.
3.
NOTE
Confirm that the wires cannot be pulled out.
4.
2.5 mm or less
Terminal screw
Euroblock plug
Loosen the Euroblock plug terminal screws.
Insert wires.
Tighten the Euroblock plug terminal screws.
Use an included wire band to attach the wires to the
Euroblock plug tab.
TASCAM MM-4D/IN-E / MM-4D/IN-X
Flat-blade screwdriver
9