Technical Data; Before Starting The Equipment; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-HA 1500 Mode D'emploi

Anleitung_BT_HA_1500_SPK1:_
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Mains voltage: 230 V~ 50 Hz
Power input:
Temperature: 375°C / Setting 1
500°C / Setting 2
Air volume: 400 l / Setting 1
550 l / Setting 2
Protection class:
Weight:

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6. Starting up
6.1 3-setting ON/OFF switch (Figure 3)
Select the required working temperature and air
volume with the ON/OFF switch (2).
Within a very short space of time the hot air gun
will reach operating temperature.
Switch position 1:
1. Setting – 375°C / 400 liters/min.
Center position:
Equipment is switched off.
Switch position 2:
2. Setting – 500°C / 550 liters/min.
6.2 Possible uses for the hot air pistol:
Removal of paint and lacquer. Attention!
Hazardous or poisonous gasses may be
produced while removing paint or lacquer.
Be sure to provide adequate ventilation.
Removal of stickers and decorations.
Loosening of rusted or tightly fastened nuts and
metal screws.
Thawing of frozen pipes, door locks, etc.
Attention: no not attempt to thaw plastic or
synthetic pipes.
12.02.2008 11:08 Uhr
Accentuation of natural wood grains before
staining or lacqueing.
Shrinkage of PVC packaging foils and insulation
tubes.
Waxing and de-waxing of skis.
Caution: Intensive heating means a higher risk of
fire and explosion! Ensure good ventilation.
Harmful and/or toxic gases and vapors may be
1500 W
emitted.
6.3 Selecting the right nozzle
The heat nozzle (4) is designed to protect e.g.
glass panes from overheating by diverting the
hot air. For removing paint.
The wide nozzle (5) provides uniform air
II /
distribution on small surfaces
The reducer nozzle (6) provides a targeted jet of
0.7 kg
heat for corners and for soldering work.
The reflector nozzle (7) is designed for soldering
and shaping tubes, for defrosting water pipes
and for shrinking insulating hoses.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Seite 9
GB
9