Pan Detection; Residual Heat Indication; Timer - CONTINENTAL EDISON CETI4Z4BFLEX Notice D'utilisation

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work: :
 If there is no pan on the heating zone or if this pan is not adapted to the induction. In this case
it is impossible to increase the power and the display shows [ U ]. This symbol disappears
when a pan is put on the heating zone.
 If the pan is removed from the heating zone the operation is stopped. The display shows [ U ].
The symbol [ U ] disappears when the pan is put back to the heating zone. The cooking
continues with the power level set before.
After use, switch the heat element off: don't let the pan detection [ U ] active.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still hot
and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Timer

The timer is able to be used simultaneous with all heating zones and this with different time settings
(from 0 to 99 minutes) for each heating zone.
 Setting and modification of the cooking time :
Action
Zone selection
Increase power
To select « Timer »
Decrease the time
Increase the time
After a few seconds the control light stops with blinking.
The time is confirmed and the cooking starts until the time reaches [ 00 ].
 To stop the cooking time :
Action
Zone selection
To select « Timer »
To stop the « Timer »
If several timers are activated repeat the process.
 Automatic stop at the end of the cooking time :
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press any key.
Control panel
Press selection zone key
Press key [ + ]
Press simultaneously [ - ] and [ + ]
Press key [ - ]
Press key [ + ]
Control panel
Press selection zone key
Press simultaneously [ - ] and [ + ]
Press key [ - ]
31
Display
[ 0 ]
[ 1 ] to [ 9 ]
Timer [ 00 ] min
[ 00 ] wents to 30,29...
time increase
Display
[ 0 ]
The remaining time
[ 00 ] then stops