Whirlpool WHAD703PAW Guide D'utilisation Et D'entretien page 8

Internal Pump Mode and Drain Hose
Connection (optional)
The dehumidifier can be set up to run continuously (depending
on selected humidity level) one of two ways:
1. Drain into a floor drain or other drain below the drain port on
the back of the dehumidifier.
2. Drain to a remote drain up to 16 feet (5 m) above the height of
the dehumidifier using the dehumidifier's internal pump.
The drain fitting uses a standard garden hose connector.
NOTE: Use GHT or "garden hose thread", which has an outer
diameter of 1 / " (27 mm) and a pitch of 11.5 TPI (threads per
1
16
inch) or use the included drain hose kit.
1.
Remove drain fitting plug
Place the dehumidifier on a level surface. Unscrew the cap on the
back of the unit to access the drain fitting, and remove the drain
plug. Keep the drain plug in a safe place for reuse.
2.
Install drain hose with included kit
If using the included drain hose kit, press the gasket into the large
end of the drain hose adapter. Then press the clear drain hose
firmly onto the small end of the adapter.
NOTE: You may also use a standard garden hose. Do not exceed
the recommended length for your installation type.
8
3.
Drain to floor drain
6 ft. MAX
(2 m)
Thread the hose clockwise securely onto the drain fitting and
place the other end into a floor drain below the height of the drain
fitting.
NOTE: To ensure proper drainage, hose length should not exceed
6 feet (2 m). Be sure there are no kinks in the hose.
OR
3.
Drain using internal pump
16 ft. MAX
(4.87 m)
Thread the hose clockwise securely onto the drain port. Route
the hose to a suitable drain. Turn on the unit and press the PUMP
button. The Pump indicator will light.
NOTE: To ensure proper drainage, hose length should not exceed
50 feet (16 m). Water may be pumped to a height of up to 16 feet
(5 m) above the drain fitting. Be sure there are no kinks in the
hose.