Whirlpool WHAD703PAW Guide D'utilisation Et D'entretien page 11

PROBLEM
Frost Appears On the
Coils
Controls Cannot Be Set
There Is Water On the
Floor
E1, E2, or E3 In Display
POSSIBLE CAUSES
The dehumidifier has recently been turned
on or the room temperature is below 41°F
(5°C).
The compressor will turn off and the fan
will automatically continue to run for
approximately 3 minutes at a fixed setting.
Air is moving through the unit.
Hose connection may be loose.
Hose is attached but not draining.
Your dehumidifier is showing an error code.
RECOMMENDED SOLUTIONS
This is normal. Frost will usually disappear within
60 minutes.
This is normal. Wait approximately 3 minutes and set the
fan speed at the desired level.
This is normal.
Check the hose connection and make sure it is tight.
See the "Continuous Mode and Drain Hose Connection"
section for more information.
Make sure the hose is placed so that the water will flow
into a drain. See the "Continuous Mode and Drain Hose
Connection" section for more information.
Contact XLS for assistance.
11