Operating The Hob With The Sensor Keys; Worth Knowing About The Slider (Touch-Control) - FORS TIFS 644 FB Instructions De Montage Et D'utilisation

Appliance description

Operating the hob with the sensor keys

The hob is operated with touch control sensor keys. The sensor
keys are operated as follows: lightly touch a symbol on the
surface of the ceramic glass plate. A buzzer will indicate when
the controls have been operated correctly.
The touch control sensor key will then be indicated as "key".
ON/OFF key (7)
This key is used to switch the entire hob on and off. It is, as it
were, the main switch.
Power setting display
The power setting display shows the power setting which has
been selected, or:
.............. Residual heat
.............. Power boost function
.............. Pan recognition
.............. Automatic boost function
.............. STOP function
.... Warming level 42°C/70°C/94°C
.............. Bridging function (operating cooking zones
simultaneously)
Symbols
.......... Child safety device / lock
.......... Keep warm function
.......... Timer function
.......... Power boost
........... STOP function
Lock key (10)
The lock key can be used to lock all of the keys.
Keep warm key (11)
For melting and simmer.
Power key (12)
The power boost setting makes additional power available for
induction cooking zones.
STOP key (13)
The STOP function can be used to briefly stop the cooking
process.
Timer key (14)
For programming the automatic switch-off device (timer) and the
minute minder.
(9)
Worth knowing about the slider (touch-
control)
In principle, the slider functions the same as the touch controls;
the only difference is that you can put your finger on the glass
ceramic surface and then move it around. The touch control
recognises this movement and raises or lowers the display
setting (power level) in accordance with the movement.
The term touch control is used to mean slider from now on.
Touch control
What must be observed when operating touch controls?
Your finger should not be placed flat onto the glass ceramic
surface in order to avoid adjacent keys/touch controls from
reacting by mistake.
finger
vitroceramic
sensor
sensor
unsuitable
Press the touch control lightly or move your finger around
You can press the touch control very lightly with your finger;
when this is done the setting on the display (power level) will
gradually change.
When you put your finger on the touch control and then move it to
the left or right, the display setting will change progressively.
The faster the movement, the faster the change in the display.
touch
Attention:
Pressing a sensor key and keeping it pressed (for approx.
3seconds) may activate the automatic boost function A.
See the section on Automatic boost function.
GB
vitroceramic
sensor
sensor
right
move
23