Rear Panel - M-Audio BX5 D2 Guide D'utilisation

Network and Power Amplifiers: The active crossover network and power amplifiers for the
BX5 D2 are specially designed for its woofer and tweeter. The network properly distributes low,
mid, and high frequencies to the driver components in order to reduce distortion and loss of
sound, thus achieving a naturally balanced sound.
In order to generate powerful, ultra-crisp sound, there are two separate power amplifiers inside
the BX5 D2 for driving the woofer and tweeter separately in a high-end bi-amp structure. The
power delivered to the woofer driver at a low-rated distortion is 40 W, and 30 W is also
delivered to the tweeter.

Rear Panel

1. XLR Input: This jack accepts XLR input
connections
unbalanced wiring. The input wiring of an
XLR connector should be as follows:
• XLR Pin 1: signal ground (shield)
• XLR Pin 2: signal positive (+)
• XLR Pin 3: signal negative (–)
2. TRS Input: This jack accepts 1/4"
connections
unbalanced wiring. For balanced wiring, a
three-conductor TRS plug is necessary.
The input wiring of a TRS connector
should be as follows:
• TRS Tip: signal positive (+)
• TRS Ring: signal negative (–)
• TRS Sleeve: signal ground (shield)
Unbalanced 1/4" wiring can be done with
either a two- or three-conductor (TS or
TRS) plug. A two-conductor (TS) plug automatically grounds the signal negative input,
whereas a three-onductor (TRS) plug, wired unbalanced, provides the option of leaving
the negative input open or grounded. We recommend that you ground the unused
negative input (this can be done by wiring the ring and sleeve of the TRS plug together).
The TRS input is summed through a balanced input amplifier with the XLR input, allowing
both inputs to be used simultaneously. Input specifications apply to both.
3. Product Specification: This label contains the model and specification information.
4. Sub-Frequency Vent Port: This port aids in reproduction of very low frequencies by
discharging frequencies below 60 Hz.
5. Volume Control: Use the volume control to set the output sound pressure from the BX5
D2 to proper levels as required.
6. Power Switch: This switch turns the monitor on and off.
7. Power Receptacle: Accepts a detachable 3-circuit line cord in order to power the monitor.
8. Fuse Holder: Holds the external main fuse.
9. Voltage-Select Switch: Provides two selections, 115V AC and 230V AC, and should be
set to match the "house supply" (receptacle) voltage of the country or location in which the
speaker is used. The 115V setting is correct for the USA, while the 230V setting is correct
for most of the UK and Europe.
with either balanced or
with either balanced or
XLR
1
2
BX5
3
Frequency Response: 56Hz-22kHz
LF Amp. Power: 40W / HF Amp. Power:30W
Input Imp.:20K ohms Bal./10K ohms Unbal.
100-120V~,50/60Hz 70W
220-240V~,50/60Hz 70W
4
Input
Volume
TRS
Power
On
Off
D2
Made in China
AC Select
4
5
6
7
8
9