Tefcold ODC60-P Manuel D'utilisation Et D'entretien page 20

Attention should be given to this tray and regular cleaning is recommended.
9. OPERATINAL TEST

CHECKS IN TE EVENT OPERATIONAL FAILURE
In some situations, operational failure can arise due to simple causes that users themselves can solve, which is why prior to requesting the
intervention of a specialised technician, we recommend that you carry out the following checks.
The appliance does not work
- Check that it is correctly plugged in.
- Check that electricity reaches the power outlet.
- Check that general switch is in the
The internal temperature is too high
-Check that there is no heat source nearby.
- Check that the grill is not obstructed.
- Check the Set-point.
- Check that the product loaded is perfectly distributed, without blocking the interior air ventilation exits and that the time elapsed since loading
has been sufficient to chill the products.
- Check if the evaporator has ice.
- Check that the condenser is not obstructed.
- Check that the appliance is functioning normally.
In the event of strange or excessive noises
- Check the levelling of the unit as this may cause vibrations.
- Check that there is no object rubbing against any movable element of the refrigerated unit.

NOISE TESTING
- The noise tests were performed in a room without any noise absorption elements and without any large item placed near to the refrigerated
unit.
- The noise levels registered in the acoustic test have been carried out in accordance with the ISO 230 to 235 standards.
Leq(continuous level) is less than 70 dB. (A)
Lp (acoustic pressure level) is less than 130 dB. (C)
NOTE. (A) (C) Frequency weights.
10. DECOMMISSIONING
Decommissioning
The refrigerator cabinet containing polyurethane foam , oil, plastic parts , metal parts and electrical and electronic components. When the life of
the furniture has come to an end and is necessary to remove the cabinet for destruction or partial recovery , the user is responsible for delivering
the product to the collection specified by the local authority for recovery and recycling WEEE professionals, always respecting the laws in force .
The manufacturer is responsible for recovery, treatment and disposal at end of product life , in direct way or through a collective system make
possible . If the rules are violated specific sanctions , established autonomously , according to the laws of each state belonging to the EC and
conformally linked to all who are subject to those rules apply
Dismantling furniture
In accordance with the rules on waste disposal in force in each country and full respect for the natural environment , we recommend subdividing
the different parts of the furniture according to the material , separately or eliminate back. This product contains HFC ,ie , fluorinated gases with
high value of greenhouse gas ( GWP). So: The component parts of the cooling circuit can not be cut or separated until the refrigerant gas has
been extracted for recovery in a specialized center.
Declaration of conformity RoHS
He declares under its own responsibility that the refrigerated cabinet to which this manual refers , meets the requirements of Directive 2002/95 /
EC / (RoHS ) In all homogeneous materials used for manufacturing , the possible existence of lead, mercury , hexavalent chromium ,
polybrominated biphenyls (PBB ) and diphenyl ether (PBDE ) does not reach 0.01% by weight . This statement is based on statements of our
suppliers of raw materials and components .
I/ON
position.
20