Installing The Anti-Tip Bracket; Setting Up The Display Rack For Your Appliance - Zephyr PRW24F02BG Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Installing the Anti-tip Bracket

1. Position anti-tip bracket at a minimum of 8" from the left or right of the side of the cooler.
2. Install anti-tip bracket to floor by using supplied 2" screws.
3. Push the cooler back into anti-tip bracket making sure the bracket overlaps the cooler bottom.

Setting Up the Display Rack for Your Appliance

Should you desire to set up the display rack for your appliance, please follow the instructions below:
1. To set up the display rack, two racks above the display rack need to be removed beforehand.
Follow the steps for removing the shelves on page 20.
2. Push underneath the display rack to lift out the front section of the rack.
3. Push and line up the legs on both the left and right side of the display rack.
4. Mount the legs of the display rack onto the split section of the back rack to lock it in place and
prevent the display rack from sliding back down.
5. Place back all the contents initially loaded on the shelf, if applicable.
18
2
4
PRW24F02BG Use, Care, and Installation Guide
P R E S R V ™
W I N E C O O L E R
D U A L Z O N E
3
5