Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
2 Insert the guide bar into the hole in the base,
then firmly tighten the wing bolts (A)
(standard accessories).
3 Make minute adjustments of the dimensions
between the bit and the guide surface with
the feed screw, then firmly tighten the 2
wing bolts (B) on top of the bar holder and
the wing bolt (C) that secures the straight
guide.
4 As shown in Fig. 12, securely attach the
bottom of the base to processed surface of
the materials. Feed the router while keeping
the guide plane on the surface of the
materials.
4. Adjusting the rotation speed
The M8V2 has an electronic control system
that allows stepless rpm changes. As shown
in Fig. 13, dial position "1" is for minimum
speed, and position "6" for maximum
speed.
5. Cutting
WARNING:
Wear eye protection when operating this
tool.
Keep your hands, face and other body parts
away from the bits and any other rotating
parts, while operating the tool.
(1) As shown in Fig. 14, remove the bit from
the work pieces and press the switch lever
up to the ON position. Do not start cutting
operation until the bit has reached full
rotating speed.
(2) The bit rotates clockwise (arrow direction
indicated on the base). To obtain maximum
cutting effectiveness, feed the router in
conformance with the feed directions shown
in Fig. 15.
NOTE:
If a worn bit is used to make deep grooves,
a high pitched cutting noise may be
produced.
Replacing the worn bit with a new one will
eliminate the high pitched noise.
14
Fig. 12
Fig. 13
Separate
Fig. 14
Router feed
Router feed
Workpiece
Rotation of bit
Fig. 15
Dial
Publicité
Table des Matières
