KREA Swiss volumeSPRAY Mode D'emploi page 7

• The spray gun is guaranteed for six months subject to the enclosed terms and on condition
that it is only used for processing products approved for the food industry.
• The spray gun is designed to work and rest intermittently and it is not suitable for industrial
use, defined as more than three minutes of operation within any eight minute period.
A maximum of 750 ml of material may be sprayed within a 3 minute period after which
a 5 minute total resting (cooling) period is required before the sprayer may be used again.
Should the spray gun be intermittently used, for periods of 20 - 30 seconds at a time, then a
resting (cooling) period of 5 - 10 seconds is sufficient. Failure to adhere to the usage &
resting (cooling) period will significantly reduce the lifetime of the sprayer and negate the
warranty.
• Only original spare parts may be used in the event of repairs.
• The spray gun must be serviced and cleaned as described in the operating instructions.
• The guarantee starts upon customer receipt. The guarantee excludes any damage due to
natural wear, overloading or incorrect handling.
REPAIRS & PRODUCT LIABILITY
Repairs are not covered by the guarantee and shall be performed by service centres subject
to the applicable price and delivery terms of the country in question.
No liability is accepted for damage caused directly or indirectly by the use and spraying of
this products. The user assumes full responsibility for the use of the product in accordance
with the laws of food hygiene and other legal regulations.
EN Declaration of Conformity CE
This product meets the required standards as set out in the following norms:
EN 50144-1:98 +A1:02 +A2:03, EN 50144-2-7:00, EN 50366:03 + A1:06,
EN 55014-1:06 + A1:09 + A2:11, EN 55014-2:97 + A1:01 + A2:08, EN 61000-3-2:06 +A1:09 +A2:09,
EN 61000-3-3:08, EN 62233:08
Guarantee
Dr. S. Kendrick A. Hitschrich
7