Table des Matières
Publicité
If you have decided to cover your house with bitumen tiles, we recommend that they are laid directly on
the roof boards.
Make sure you remove the film on the bitumen strips before laying!
The threaded rods of the wind safety device are only tightened by hand. Ensure that the helical springs remain
released while the rods are installed.
Ensure that no rigid connections of the individual wall boards occur beneath each other, e.g. by installing a shelf,
a gutter downpipe or similar, so that these can work unhindered.
The possibility of differing wood moisture + tolerances in individual components may lead to variations in
dimensions, particularly in the area of the pediment/side wall height,
which must be adjusted during installation using appropriate means (e.g. electric plane).
The window/door panes must be sealed all round with transparent silicone for windows immediately after
assembly and painting to ensure full resistance to driving rain.
Otherwise extreme rainfall may lead to interior leaks which cause discoloration and damage to the wood. The
manufacturer will accept no liability for such damage, there will be no replacement within the scope of the
guarantee nor is it covered by the manufacturer's warranty. We therefore refer you again to our guarantee
conditions at this point.
5.5 Tools
You should have the following tools to hand before beginning assembly:
Tape measure
Drill
Electric screwdriver Hammer Pencil
Burring iron
Rubber mallet
Saw
Universal cutter
Cord
Spirit level
Spanner
Vice
5.6 Abbreviations
RW = Rear wall
WS = Wall thickness
We hope you have a successful installation and wish you many happy hours enjoying your weka product.
Copyright HRB 3662
Techn. Änderungen vorbehalten!
Alle Maßangaben sind ca. Maße.
14
Publicité
Chapitres
Table des Matières
