Base Installation - Honeywell T822 Série Mode D'emploi

English: Page 1 • Français:

Base installation

1 Pull wires through wire hole.
Position base on wall, level
and mark hole positions.
2 Drill holes (3/16" for drywall,
7/32" for plaster), then tap in
supplied wall anchors.
3 Pull wire through base, posi-
tion over anchors, then insert
and tighten mounting screws.
Check level if desired.
Wiring
1 Loosen screw terminals, insert bare
wires beneath screws, then re-tighten
screws.
2 Push excess wire back into the wall
opening.
3 Plug the wall opening with nonflam-
mable insulation to prevent drafts
from affecting thermostat operation.
Terminal Designations
R Heating power. Connect to secondary
side of heating system transformer.
W Heat relay.
Wire specifications
Use 18-gauge thermostat wire. Shielded
cable is not required.
Page 6 • Español: Página 11
3