Mounting Points - Evolite EVO Spot 60-CR Mode D'emploi

from a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept
at least 0.5m (1.5 f t) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental
damage and/or injury in the event the clamp fails.

Mounting points:

Overhead mounting requires extensive experience, including amongst others calculating
working load limits, a fine knowledge of the installation material being used, and periodic
safety inspection of all installation material and the fixture. If you lack these qualifications, do
not attempt the installation yourself. Improper installation can result in bodily injury.
Be sure to complete all rigging and installation procedures before connecting the main power
cord to the appropriate wall outlet.
Clamp Mounting:
This moving head provides a unique mounting bracket assembly that integrates the bottom of
the base, and the safety cable rigging point in one unit (see the illustration below). When
mounting this fixture to truss be sure to secure an appropriately rated clamp to the included
omega bracket using a M10 screw fitted through the center hole of the "Hanging Kit". As an
added safety measure be sure to attached at least one properly rated safety cable to the fixture
using on of the safety cable rigging point integrated in the base assembly
DMX IN
POWER IN
Evo Spot 60-CR User's Manual Ver. 1.00
POWER IN
2 1
Signal (-)
Signal (+)
DMX512 OUT
POWER IN
Signal
Signal (+)
1 2
Ground
120 Ω
DMX512 IN
(-)
18
Page