Initial Operations & Safety Instructions - ECS 2000 Manuel D'utilisation

3. Initial operations & safety instructions
1. Make sure to use the correct voltage. See the information on the
device and in this manual.
2. Make sure that the device is not connected to the mains during
installation.
3. Installation has to be done by technical experienced and qualified
persons according to safety regulations of the respective country.
4. Always ensure that maximum permissible exposure (MPE) is not
exceeded in areas accessible to the public.
5. In some countries an additional inspection by technical control
institutes could be necessary.
6. Connect an easily accessible interlock connector or circuit breaker
to the projector.
7. The power supply should be easily accessible.
8. When installing the laser, mount it with a minimum distance of
15 cm from walls and objects.
9. If the device has been exposed to great temperature changes, do
not switch it on immediately.
10. Never use Dimmer, RC or other electronically switched sockets.
Whenever possible, do not use the laser projector together with
large appliances (especially fog machines) on the same mains!
11. Ensure sufficient ventilation and do not place the device on any
surface which is radiating warmth or heat. Especially the ventilation
openings must not be covered!
12. Ensure that device does not overheat. Make sure that the device is
not exposed to spotlights (especially moving heads). The spotlights
could overheat the laser quickly and lead to a degradation of
peformance.
13. Attach the safety cable to the device and ensure its proper fixation.
14. When operating problems occur, stop using the device and contact
your dealer immediately.
4
english • français