Troubleshooting - AGA marvel HEARTLAND HCBMR19 Instructions D'utilisation

Refrigerator Operation
The refrigerator will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power cord unplugged?
Is outlet working? Plug in a lamp to see if the outlet is
working.
Household fuse blown or circuit breaker tripped?
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Are controls on? Make sure the refrigerator controls are on.
See "Using the Control(s)."
New installation? Allow 24 hours following installation for the
refrigerator to cool completely.
NOTE: Adjusting the temperature controls to coldest setting
will not cool either compartment more quickly.
The motor seems to run too much
Your new refrigerator may run longer than your old one due to its
high-e ciency compressor and fans. The unit may run even
longer if the room is warm, a large food load is added, doors are
opened often, or if the doors have been left open.
The refrigerator seems noisy
Refrigerator noise has been reduced over the years. Due to this
reduction, you may hear intermittent noises from your new
refrigerator that you did not notice from your old model. Below are
listed some normal sounds with explanations.
Buzzing - heard when the water valve opens to ll the ice
maker
Pulsating - fans/compressor adjusting to optimize
performance
Hissing/Rattling - ow of refrigerant, movement of water
lines, or from items placed on top of the refrigerator
8

TROUBLESHOOTING

Plug into a grounded 3 prong outlet.
Replace
Sizzling/Gurgling - water dripping on the heater during
defrost cycle
Popping - contraction/expansion of inside walls, especially
during initial cool-down
The doors will not close completely
Door blocked open? Move food packages away from door.
Bin or shelf in the way?
position.
The doors are di cult to open
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Gaskets dirty or sticky?
with mild soap and warm water. Rinse and dry with soft cloth.
Temperature and Moisture
Temperature is too warm
New installation? Allow 24 hours following installation for the
refrigerator to cool completely.
Door(s) opened often or left open?
refrigerator. Minimize door openings and keep doors fully
closed.
Large load of food added?
refrigerator to return to normal temperature.
Controls set correctly for
Adjust the controls a setting colder. Check temperature in
24 hours. See "Using the Control(s)."
There is interior moisture buildup
NOTE: Some moisture buildup is normal.
Humid room? Contributes to moisture buildup.
Door(s) opened often or left open?
refrigerator. Minimize door openings and keep doors fully
closed.
Push bin or shelf back in the correct
Clean gaskets and contact surfaces
Allows warm air to enter
Allow several hours for
the surrounding conditions?
Allows humid air to enter