Switching Off The Device - Hama BASIC L42A Mode D'emploi

g
4.3 Lamination
Place the document to be laminated in the appropriate pouch (see
gure).
Insert the lm pouch into the front opening of the device (4).
sure that the sealed end is inserted rst.
NOTE
The document is returned at the rear (5).
If an item has not been fully laminated, repeat the rst steps.
CAUTION!
NOTE

4.4 Switching off the device

Press the on/off switch
lamp
8
Film pouches of all sizes should be inserted at the centre of
the front opening so that they pass through the sensor.
Laminated items coming out of the device may be too hot to
touch.
The laminated sheet is hot and can be bent easily. Place the
item on a at surface and leave to cool so that it does not
curl at the edges.
2
goes out.
3
to switch off the device. The ready
ake
Basic L42A