Affichage Des Voyants Led - T&D RTR-500NW Manuel D'utilisation

Affichage des voyants LED

LED Status
ON BLINKING
ACTIVE
ACTIVE
DIAG
ACTIVE
ACTIVE
ALARM
30 Notes sur l'utilisation
ACTIVE
DIAG
OFF
Network communication available
Connected via USB
Network communication in progress
(wireless communication with Remote Unit)
USB communication in progress
Initializing after power turned ON
FTP or E-mail transmission failed
Clock Settings not completed
Clock settings have been reset
(power failure and so on)
No Remote Units have been registered
FTP or E-mail settings have not been properly made
DIAG
No Settings for autonomic operations such as
monitoring have been made
Failed to connect to wireless LAN access point
(only RTR-500AW)
IP address cannot be received from DHCP server
DIAG
A measurement has exceeded the set upper or lower
limit
A Remote Unit wireless error has occurred
The contact input is ON
There is trouble in the Remote Unit (battery level is
low, a sensor connection is poor, etc...)
POWER
ALARM
Description