Danby DWM055A1WDB-6 Manuel Du Propriétaire page 7

INSTALLATION INSTRUCTIONS
Connecting the Quick Connect Assembly to
the Water Supply
Pull down on the locking collar and pull up on the
faucet adapter to remove the adapter from the
assembly.
Remove the aerator from the faucet before attaching
the faucet adapter.
If the water supply faucet is female threaded, (left
image below), use both the thick and thin washers
in the connection.
If the water supply faucet is male threaded,
(right image below), use the thick washer in the
connection.
Turn on the faucet to check for leaks at the
connection before continuing. If leaks are present,
it may be necessary to wrap the faucet adapter or
the faucet with Tefl on tape before connecting the
adapter to the faucet.
Pull down on the locking collar and push the Quick
Connect assembly onto the bottom of the faucet
adapter. Release the locking collar to attach the
Quick Connect to the faucet.
Attach the water inlet hose to the inlet hose
connection on the Quick Connect assembly by
turning the connecting nut. Ensure that there is a
rubber gasket in the connection to prevent leaks.
Leave the cap in place on the lower drain hose
connection on the Quick Connect assembly as it is
not necessary for this appliance.
Attach the other end of the water inlet hose to the
cold water connection on the back of the appliance.
Leave the cap in place on the hot water connection
and ensure that there is a rubber gasket in both
connections to prevent leaks.
Important: After a wash program is complete, press
the pressure release valve to release any water in
the inlet hose before removing the Quick Connect
from the faucet.
6