Danby DWM045WDB Manuel Du Propriétaire page 7

INSTALLATION INSTRUCTIONS
Attach the water inlet hose to the inlet hose
connection on the Quick Connect assembly by
turning the connecting nut. Ensure that there is a
rubber gasket in the connection to prevent leaks.
Leave the cap in place on the lower drain hose
connection on the Quick Connect assembly as it is
not necessary for this appliance.
Attach the other end of the water inlet hose to the
cold water connection on the back of the appliance.
Leave the cap in place on the hot water connection
and ensure that there is a rubber gasket in both
connections to prevent leaks.
Important: After a wash program is complete, press
the pressure release valve to release any water in
the inlet hose before removing the Quick Connect
from the faucet.
Using a Direct Hose Connection
If there are both hot and cold water faucets
available, this appliance can be directly connected
to the water supply using the steps below.
Connect both provided inlet hoses to the hot and
cold faucets. Ensure that there is a rubber gasket in
both connections to avoid leaks.
Attach the other ends of the water inlet hoses to
the hot and cold water connections on the back of
the appliance. Ensure that the cold water faucet
is connected to the cold water inlet and that the
hot water faucet is connected to the hot water
inlet and that there are rubber gaskets inside both
connections to avoid leaks.
DRAIN HOSE INSTALLATION
The drain hose will arrive pre-attached to the
appliance. During operation of the appliance, the
drain hose should be directed toward a sink or
drain to catch the discarded water as it exits the
appliance.
When running the drain hose to a drain, ensure that
there are no bends in the hose as this can cause a
blockage and impede the drain function.
The drain hose can be directed upward toward a
sink or bucket but ensure that the hose does not rise
more than 120 cm (47.3 in) from the ground as this
can impact the drain function.
6