Table des Matières
Publicité
6. Informations Concernant les Réglementations
CE Declaration of Conformity
This product is in conformity with the following
standards
v
EN60950-1:2006 (Safety requirement of
Information Technology Equipment).
v
EN55022:2006 (Radio Disturbance
requirement of Information Technology
Equipment).
v
EN55024:1998+A1:2001+A2:2003
(Immunity requirement of Information
Technology Equipment).
v
EN61000-3-2:2006+A1:2009+A2:2009
(Limits for Harmonic Current Emission).
v
EN61000-3-3:2008 (Limitation of Voltage
Fluctuation and Flicker) following provisions
of directives applicable.
v
2006/95/EC (Low Voltage Directive).
v
2004/108/EC (EMC Directive).
v
2005/32/EC (EuP Directive, EC No.
1275/2008 mplementing Directive
for Standby and Off mode power
consumption) and is produced by a
manufacturing organization on ISO9000
level.
The product also comply with the following
standards
v
ISO9241-307:2008 (Ergonomic
requirement, Analysis and compliance test
methods for electronic visual displays).
v
GS EK1-2000:2009 (GS mark requirement).
v
prEN50279:1998 (Low Frequency Electric
and Magnetic fields for Visual Display).
v
MPR-II (MPR:1990:8/1990:10 Low
Frequency Electric and Magnetic fields).
Energy Star Declaration
(www.energystar.gov)
As an ENERGY STAR
have determined that this product
meets the ENERGY STAR
guidelines for energy efficiency.
Note
®
Partner, we
®
22
We recommend you switch off the monitor
when it is not in use for a long time.
Federal Communications Commission (FCC)
Notice (U.S. Only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
v
Reorient or relocate the receiving antenna.
v
Increase the separation between the
equipment and receiver.
v
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
v
Consult the dealer or an experienced
radio/TV technician for help.
Publicité
Table des Matières
