Replacing Battery; Get Started; Auto Standby; Use - THOMSON SB250BT Mode D'emploi

Replacing battery

Replacing battery
The remote control works with lithium button cell The remote control works with lithium button cell
CR2025 3V batteries. When the remote no longer CR2025 3V batteries. When the remote no longer
works you need to replace the batteries as follows: works you need to replace the batteries as follows:
• Press the tab on the side of the battery cover to • Press the tab on the side of the battery cover to
release it and allow the battery support to come out. release it and allow the battery support to come out.
• Replace the battery paying attention to the correct • Replace the battery paying attention to the correct
orientation of the poles. orientation of the poles.
• Replace the battery support pushing it inside until you hear a "click". • Replace the battery support pushing it inside until you hear a "click".
ATTENTION: Danger of explosion if batteries are not inserted correct. ATTENTION: Danger of explosion if batteries are not inserted correct.

Get started

Power
CAUTION
• Risk of product damager! Make sure that the power voltage
corresponds to the voltage printed on the back label.
• Risk of electric shock! When you unplug the AC power cord
always pull the plug from the socket. Never pull the cord.
• Before connecting the AC power cord, ensure you have
completed all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply
socket and switch on if applicable.

Auto standby

When playing media from a connected device, the Tower automatically switches to standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.

Use

Play from external audio
You can play from an external audio device such as MP3 player through this unit.
Optical in Jack (Requires an optical cable)
1. Connect an Optical cable to the optical jack on back panel. Connect the other end of the Optical
cable to the digital audio device.
2. Press the button to turn the unit on.
3. Press the MODE button to switch to Optical In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
Line in Jack (Requires a 3.5mm cable)
1. Connect a 3.5mm cable to the Line jack on top panel. Connect the other end of the 3.5mm cable
to an Mp3 player or other audio device.
2. Press the button to turn the unit on.
3. Press the MODE button to switch to Line In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
- EN 5 -
CR2025 CR2025