König SAS-IPCAM111B/W Mode D'emploi page 3

After the software installation is complete,
2
click the icon
Default "uCare Cam" password:
00000000
Manager's Name: admin Manager's
Password: 0000
There are two options to continue the easy set up of your IP camera.
Install your IP camera by ROUTER MODE
Power On
1
Plug the power adapter DC connector into the DC input port of the
IP camera and then plug the power adapter into a wall outlet. The
status LED on the IP camera will turn green for about 15 seconds.
Programme Loading
2
The status LED will flash red for about 15 seconds.
Router Link Mode
3
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset
button for more than 10 seconds to restart the IP camera.
When the green status LED lights up and holds, and then the red
status LED flashes twice, after which it changes into green, the IP
camera has entered the RESET state. At this moment you can release
the button and then wait until the status LED alternates between
red and green.
ANDROID (for Apple go to: Step 8)
Set the IP camera to connect to the Wi‑Fi Router
4
Open the "uCare Cam" App
the Camera List Window (see "Figure 1").
to run the app.
and select:
3
Figure 1
"Camera List Window"
in the screen of
ENGLISH