Tintometer Lovibond TC Série Mode D'emploi page 16

26. Unscrew the pin.
Use the spanner provided.
27. Screw in the pin on the opposite side.
28. Unscrew hinge
bracket.
29. Remote the cover, turn it through 180°
and re-fit it on the opposite side.
30
16
27
26
28
29
30. Screw hinge brack-
et into place.
31
31. Insert the pin into the left-hand door mounting.
Use your index finger to hold the pin
while you are assembling the door.
32. Locate the door on the upper pin as
shown in the illustration and guide
it to the lower hinge bracket.
Important
As a result of its heavy weight, the door
must be held secure by one person.
33. Lift the door upwards and turn
the pin until it fits into the bore
hole of the hinge bracket.
Slowly lower the door down-
wards. The lower part of the pin
must be fully engaged in the
bore hole of the hinge bracket.
34. Screw the screw into the
pin again and tighten.
32
33
TC 140 G / TC 256 G_3 12/2020
34