Table des Matières
Publicité
Preparación (cont.)
Ubique los dos orificios de fijación del lavabo; marque el lugar en la pared.
Marque el lugar del orificio del pedestal en el piso.
Con cuidado retire el lavabo del pedestal y retire ambos el lavabo y el pedestal
del área de instalación.
2.
Install the Lavatory
Install hanger bolts.
Installer les boulons d'ancrage.
Instale los pernos de sujeción.
Back of Pedestal
Arrière de la colonne
Parte posterior del pedestal
CAUTION: Risk of product damage. Do not overtighten connections.
Overtightening may break or chip the lavatory or pedestal.
Drill 1/4" mounting holes at the marked locations on the finished wall and the
floor.
NOTE: You may also use other fastening devices of sufficient size and strength.
Install the hanger bolts to the backing material so they extend 1" (2.5 cm) from the
finished wall.
Move the pedestal over the drilled hole in the floor, and carefully secure the
pedestal to the floor with a lag bolt and washer.
Carefully set the lavatory basin on the pedestal so the hanger bolts extend through
the mounting holes.
Verify the basin is positioned as desired.
Install the cap nuts and washers to the hanger bolts; carefully tighten until secure.
Do not overtighten.
1121436-2-A
Finished Wall
Set basin on pedestal.
Mur fini
Placer le bassin sur la colonne.
Pared acabada
Coloque el lavabo en el pedestal.
Pedestal
Colonne
Pedestal
Secure pedestal with lag bolt and washer.
Sécuriser la colonne avec le tire-fond et
la rondelle.
Fije el pedestal con el perno de fijación y
la arandela.
8
Basin/Bassin/Lavabo
Install cap nuts and
washers to the hanger
bolts.
Installer les écrous
borgnes et les
rondelles sur les
boulons d'ancrage.
Instale los tapones
roscados y las
arandelas en los
pernos de sujeción.
Kohler Co.
Publicité
Table des Matières
