EIBENSTOCK EMF 150 Notice Originale page 18

Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and follow the
instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
ƒ
Do not use the tool in an environment with danger of explosion.
ƒ
Do not drill into asbestos-containing materials.
ƒ
Modifications of the tool are prohibited.
ƒ
Never use the machine without dust guard.
ƒ
Always check the tool, cable and plug before use and plug before use.
Have damages only repaired by specialists.
Insert the plug into the socket only when the tool switch is off.
ƒ
When you work outside, the machine has to be used with a fault-current
circuit breaker with max. 30 mA.
ƒ
The machine should only work under supervision of somebody.
Plug and switch the machine off if it is not under supervision, in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
ƒ
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
ƒ
Don't use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
ƒ
Pay attention that the speed indicated on the cutting disc meets or
is higher than the max. speed indicated on the machine.
ƒ
Use only diamond cutting wheels for your power tool.
ƒ
Wheels must be used only for recommended applications. For example :
do not grind with the side of cutting wheel.
ƒ
Cutting wheels have to be stored and used carefully according to the
instructions of the producer.
ƒ
Cutting discs flanges and other accessories must properly fit on the
spindle of the power tool. Do not use any reducing pieces or adapters.
ƒ
Check the accessories before use. Do not use any products which are
broken, cracked or damaged in another way.
ƒ
Before use, make sure that the tool is correctly fixed and fastened.
18