Hama BASIC L47A Mode D'emploi page 8

g
4.3 Lamination
Place the document to be laminated in the appropriate pouch (see
gure).
Insert the lm pouch into the front opening of the device (1). Make
sure that the sealed end is inserted rst.
NOTE
‹ The document is returned at the rear (7).
‹ If an item has not been fully laminated, repeat the rst steps.
‹ Press the roller release button (6) on the back of the device to
run the item through again (if it was pulled in at an angle, etc.).
CAUTION!
NOTE
4.4 Switching off the device
‹ Move the On/Off switch (4) on the right-hand side of the device
to position 0. The power lamp (3) and ready lamp (2) will go out.
8
Film pouches of all sizes should be inserted at the centre of
the front opening so that they pass through the sensor.
Laminated items coming out of the device may be too hot to
touch.
The laminated sheet is hot and can be bent easily. Place the
item on a at surface and leave to cool so that it does not
curl at the edges.
Basic L47A