Detaching The Front Panel - Tokai LAR-100B Manuel D'utilisation

2. WIRE CONNECTION & INSTALLATION
INSTALLATION
PRECAUTIONS
• Choose the mounting location carefully so that the unit will not interfere with the normal driving functions
of the driver.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight
or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Be sure to remove the front panel before installing the unit.
NOTE: Inclination angle for car radio installation must not exceed 30˚ otherwise the front panel will not open.
1
release screw and
bracket
1
Note: Keep the release key in a safe place as you may need it in future to remove the unit from the car.
TO SUPPORT THE UNIT
1. UNIT
2. RELEASE CASE
3. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
10. M5 X 15 HEX BOLT
Detaching and attaching the front panel
The front panel of this unit can be detached in order to prevent the unit from
being stolen.

DETACHING THE FRONT PANEL

Before detaching the front panel, be sure to press the
press the button
Note: Be sure not to drop the panel when detaching it from the unit.
A
Notes:
• Make sure that the front panel is in the right way up when attaching it to the unit as it cannot be attached
upside down.
• Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing
it lightly against the unit.
• When you carry the front panel with you, put it in the supplied front panel case.
• Do not press hard or give excessive pressure to the display window of the front panel when attaching
it to the unit.
2
2
and detach the panel by pulling it towards you as illustrated.
B
3
TAP
182mm
53mm
Bend these
claws, if necessary
3
Dashboard
2
10
1
button to OFF first. Then
EN-15
4
4
4
6
5
8
A
7
4
B
5
6
9