Casselin CSM1 Mode D'emploi page 15

Installation & use:
EN
Installation:
- The hand dryer can be installed in a bathroom, in a kitchen, or toilet ...
- The appliance must be kept 110cm above any surface, away from all doors and splashing water such as
sinks, bathtubs, etc.
- Drill four separate holes in the wall as shown in the diagram above
- Fix the body of the machine at the desired location on the wall
- After the machine body is attached, attach the shell to the wall.
- Connect the device and test it.
Use :
- The device is designed to operate automatically. Place hands under the hand dryer. The device will
activate automatically.
Warning :
- Make sure the hand dryer is correctly attached to the wall
- Do not hit the hand dryer against other objects
- Keep the electrical device away from liquids
- Do not install the device in a room with a high concentration of dust
- the device must only be installed by professionals
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.