Danby DPF074B1WDB Guide D'utilisation page 9

DOOR REVERSAL INSTRUCTIONS
9 Unscrew and remove the bottom hinge pin.
Turn the bracket over and replace the hinge
pin.
10 Re-attach the bottom hinge bracket on the left
side. Re-attach both adjustable feet. Re-attach the
lower door in the proper position, by fitting it on the
hinge.
11 Rotate the middle hinge by 180° and line it up on
the left side in the appropriate position. Place the
middle hinge pin into the upper hole of the lower
door, and then tighten the bolts.
• Ensure the freezer door is aligned horizontally and
vertically, so that the seals are closed on all sides
before finally tightening the hinge.
12 Re-attach the upper door. Ensure that the door is
aligned horizontally and vertically so that the seals
are closed on all sides before finally tightening the
upper hinge.
13 Insert the upper hinge bracket and screw it to the
top of the unit.
14 Use a spanner to tighten it if necessary.
15 Re-attach the top cover and then re-attach the
screws which hold it in place.
16 With the doors closed, check that the doors are
aligned horizontally and vertically, and that the
seals are closed on all sides before finally tighten-
ing the bottom hinge. Re-adjust the leveling feet as
needed.
Unscrew
Screw
screw
7
Screw