Danby DPF074B1WDB Guide D'utilisation page 8

DOOR REVERSAL INSTRUCTIONS
• If you find the direction of opening the door on your appliance
inconvenient, you can change it. Holes on the opposite side
have already been prepared in the factory.
1 Tilt the unit slightly towards the rear and prop it securely. Two
people are required to tilt the unit during the door reversal
process.
2 On the top of the unit, remove the 4 screw covers, then undo
the screws underneath.
3 Lift the top cover away from the fridge.
4 Remove the three screws. Then remove the upper hinge that
holds the door in place. Lift the door and place it on a padded
surface to prevent it from scratching.
5 Remove the bolt with a screwdriver and flip the hinge bracket.
Then re-attac h the bolt to the hinge bracket.
6 Take off the middle hinge by removing the screws. Then lift
the lower door and place it on a padded surface to prevent it
from scratching.
7 Move the hinge hole covers on the panel between the fridge
and freezer from the left side to the right side.
8 Remove the adjustable feet from both sides. Remove the
screws and the bottom hinge.
180°
6
unscrew
Unscrew