Audio Settings - Kenwood KDC-X799 Mode D'emploi

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CONTROL], then press the
knob.
3
Turn the volume knob to make a selection (see the following
table), then press the knob.
4 Repeat step 3 until the desired item is selected or activated.
5 Press and hold to exit.
(or using RC-406)
1 Press AUD to enter [AUDIO CONTROL].
Press J / K to make a selection, then press
2
To return to the previous setting item, press
SUB-W LEVEL –15 to +15 (0)
For :
BAND1 LEVEL –8 to +8 (+6)
BAND2 LEVEL –8 to +8 (+6)
BAND3 LEVEL –8 to +8 (+7)
BAND4 LEVEL –8 to +8 (+3)
BAND5 LEVEL –8 to +8 (0)
For :
BASS LEVEL –8 to +8 (+6)
MID LEVEL –8 to +8 (+5)
TRE LEVEL –8 to +8 (0)
.
.
Default: XX
Adjusts the subwoofer output level.
The sound elements (frequency level, tone level,
Q factor) are preset into each selection (BAND1
LEVEL to BAND5 LEVEL).
Adjusts the level to memorize for each source.
(Before making an adjustment, select the source
you want to adjust.)
Adjusts the level to memorize for each source.
(Before making an adjustment, select the source
you want to adjust.)
EQ PRO (for )
BASS ADJUST BASS CTR FRQ
BASS LEVEL
BASS Q FACTOR
BASS EXTEND
MID ADJUST MID CTR FRQ
MID LEVEL
MID Q FACTOR
TRE ADJUST TRE CTR FRQ
TRE LEVEL
PRESET EQ DRIVE EQ/ TOP40/ POWERFUL/ ROCK/ POPS/ EASY/ JAZZ/ NATURAL/
USER: Selects a preset equalizer suitable to the music genre. (Select [USER]
to use the customized settings.)
[DRIVE EQ] is a preset equalizer that reduces noise outside the car or
running noise of the tyres.
BASS BOOST LEVEL1/ LEVEL2/ LEVEL3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS LEVEL1/ LEVEL2: Selects your preferred low and high frequencies boost to
produce a well-balanced sound at a low volume level. ; OFF: Cancels.
For :
EXTRA EQ LEVEL1/ LEVEL2/ LEVEL3: Selects your preferred elevation level to enhance
the sound in [PRESET EQ]. ; OFF: Cancels.
SUBWOOFER SET ON: Turns on the subwoofer output. ; OFF: Cancels.
60HZ/ 80HZ/ 100HZ/ 200HZ: Selects the center
frequency.
–8 to +8 (+6): Adjusts the level.
1.00/ 1.25/ 1.50/ 2.00: Adjusts the quality factor.
ON: Turns on the extended bass. ; OFF: Cancels.
0.5KHZ/ 1.0KHZ/ 1.5KHZ/ 2.5KHZ: Selects the center
frequency.
–8 to +8 (+5): Adjusts the level.
0.75/ 1.00/ 1.25: Adjusts the quality factor.
10.0KHZ/ 12.5KHZ/ 15.0KHZ/ 17.5KHZ: Selects the
center frequency.
–8 to +8 (0): Adjusts the level.
ENGLISH
19