Troubleshooting - Wolf Gourmet WGCM100S Guide D'utilisation Et D'entretien

Troubleshooting

LCD displays "ADD WATER"
• Tank is empty.
• Water level in tank is lower than the height of the float. Minimum water level is 2 cups
of water.
• Float may be stuck. Remove reservoir and shake it.
LCD displays "ADD COFFEE"
• Ensure brew basket is in place and drawer is fully closed.
• Remove coffee from basket, leaving the brew basket in the drawer. Zero scale, then
add coffee.
Coffee scale always displays weight in ACCU-BREW mode
• Add brew basket and paper filter to the drawer with no coffee. Zero scale, then add
coffee. Scale must always be zeroed with brew basket in place before adding coffee
for accurate scale readings.
LCD displays "WATER FILTER"
• Water filter needs to be replaced. See "Wolf Gourmet Coffee System Parts and
Features" page for instructions on how to order a new filter.
• WATER FILTER reminder will not disappear from display until the counter is reset. To
reset WATER FILTER reminder, turn Mode Selector Bezel to CLEAN, and hold down
the ZERO button until WATER FILTER reminder is removed.
Coffee is not dispensing
• Ensure carafe is in place.
• Overflow protection may be activated. If a lot of coffee is added and brew basket is
about to overflow, the scale will detect this and the heater will turn off to allow the
basket to drain. Once the coffee has drained to a certain level, the heater will turn back
on and finish the brew. The unit will continue to display BREWING while this feature is
activated.
Coffee tastes bad
• Too much water or too little water was added.
• Too much coffee or too little coffee was added.
• Poor coffee quality or freshness.
• Poor water quality. Use filtered or bottled water for better taste.
19