Fiamma 98655-278 Instructions De Montage page 7

98655-277
(300)
A1
A2
B
APPLICATION
EN
INSTALLATION
Look at the diagram to locate the position of the adapters. When installing the brackets,
make sure that they are aligned.
A3 - Full length adapter (page 14-15)
- Fastening with the furnished fastening material:
1) Place the profi le so that enough space is left for fastening the counter plates inside the
vehicle and mark the position of the four square holes.
2) Drill Ø6.5mm holes right through the roof.
3) Put silicone paste into the holes.
4) Put the gaskets in correspondence with the holes.
5) Install the adapter profi le with the provided bolts an counterplates. Drill Ø3mm holes
right through the small holes of the adapter in the vehicle wall. Fill the drilled holes up
with silicone paste and screw in the screws as shown. Attach the sideplates with the
Ø4.2x25mm screws.
6) Fasten the Fiamma awning to the adapter profi le.
7) Drill 3 small holes Ø5.2mm in the bottom of the box and fasten the awning with the
Ø5x12mm screws you will fi nd inside the Fiamma installation kit.
OPTIONAL (page 15
length of the adapter profi le as shown. Position the profi le on the vehicle.
KIT
HYMERCAMP 98655-278
ADAPTER
98655-276 98655-274
(350)
E
C
E
A1/A2 - Kit (page 13-15)
) - Fastening with SIKA 252 white glue. Put the glue on the full
5a
HYMERCAMP
98655-275
(400)
KIT KIT
A1
ADAPTER
FIAMMASTORE
98655-273
(450) (500)
A2
7