Factory Reset The System; Reset A Source Button On The Remote Control; Service Connectors On The Acoustimass Module - Bose CineMate 120 Notice D'utilisation

Care and Maintenance

Factory reset the system

To troubleshoot problems, reset the System menu and ADAPTiQ
factory settings.
1. Press
2. until 16 FACTORY RESET appears on the display.
Press
3. Press 5.
The system resets.
4. Run the ADAPTiQ audio calibration (see page 18).

Reset a source button on the remote control

If you are experiencing problems with a source button on the remote control, reset
the source button to the factory settings.
Note: After performing this procedure, your source button is in CEC mode.
1. On the remote control, press and hold the appropriate source button until all
six source buttons glow, then release.
Only the appropriate source button glows.
2. On the number keypad, enter 0140.

Service connectors on the Acoustimass module

The Service and Data connectors are for service use only. Do not insert any cables
into these connectors.
30 - English
on the remote control.
to the
®