YASIN U650CV-UMC Guide De L'utilisateur page 52

Input source and channel reception tekst
Use the TV
Make the connection with the desired receiving mode. The connection for DVB-C
(cable / Coax) and DVB-T (antenna) can be found at the rear. For DVB-S reception
(satellite), use the corresponding connection on the rear panel.
DVB-T (antenna)
Whether and how many DVB-T channels can be received by this device is highly
dependent on the location and DVB-T signal strength in the area. DVB-T radio in
particular is very limited and not available at most locations. Please note that if
you use the TV in a different area than before, you must reset the channels. This is
because the frequencies of the channels are very different from region to region.
Channels marked with (internet) are linked to the internet and cannot be used.
DVB-C (cable / coax)
The programs can be received analogue or digital via DVB-C. If possible, prefer the
digital receive mode. In this mode, more channels are available with better picture
quality.
Coded channels (via provider or satellite)
You can also receive coded TV channels via satellite or DVB-C. That is why you
need a box or Cam module and a SMART CARD from your service provider. Which
programs can be used depends on the contract.
Module and smart card are not included in the delivery. Activating the card can take
a few minutes when it is used for the first time. The device controls the module after
each activation. Note the manual for CI + module and smart card. Only CI + modules
and cards can be used. Other models are not supported.
Indication for CI +
Please note that the recording and time shift function may be limited on some
channels. Recorded files from channels encoded via CI + Card can only be played
on this device. This is limited by the program and we as the manufacturer are not
responsible for this.
Source
Select the correct input source on your TV (eg antenna, satellite cable, HDMI port) by
pressing the SOURCE button on your remote control.
Confirm your choice with
OK
12