How To Connect - cahors TVT 290 HD-T2 Manuel D'utilisation

How to Connect

Refer to the diagram on page 7 for the location of the sockets identified by numbers in the
procedures in this section.
Make sure you have installed the batteries in the remote control before you begin connecting the
receiver to your TV. Depending on the connection method you choose, you may need to adjust
certain settings using the remote control before you can see a digital broadcast.
Step 1: Connect to the antenna
Connect the antenna lead coming from your antenna wall plate to the TV ANT IN socket on the STB.
Step 2: Choose an installation method
There are a number of methods of connecting the STB. These methods are labelled A, B, C and D
below.
A: High Definition Multimedia Interface
If your TV has an HDMI socket, connect an HDMI cable between the HDMI socket on the STB (socket
2) and the HDMI socket on your TV.
A HDMI connection incorporates video and audio. You do not need to make separate connections for
audio.
An HDMI cable is not provided with the
STB.
9