Belkin PureAV PF30 Manuel D'utilisation page 9

Hookup and Installation
Step 3
Connect Audio Components to the Audio Filter
The Belkin PureAV Power Console Model PF30 contains an isolated Audio
Filter that is optimized to clean and condition the power to all of your
audio components. The audio filter also isolates your audio components
from connected video and high-current audio components. The Audio
Filter outlets are "Switched" and are controlled by the "Switched" button
on the front of the Power Console.
A. Attach Belkin PureAV power cord labels to each component's power
cord before you plug the cord into the corresponding outlet on the
Power Console.
B. Tape – Connect your tape player power cord to the outlet labeled
"Tape".
C. CD – Connect your CD player power cord to the outlet labeled "CD".
D. Receiver (Preamp) – Connect your receiver or preamp power cord to
the outlet labeled "Receiver".
Note: You can connect any type of audio component into the Audio
Filter outlets. You are not limited to the components listed above.
8