VESUVIO VESIN10 Manuel D'installation Et D'utilisation page 29

BE机
Size(mm)
Model
VESIN36T
※
Above data is subject to modification without notice.
2.2.2. Heat pump installation.
① The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid; the bracket must be strong enough and anti-rust
treated;
② The heat pump needs a water pump (Supplied by the user). The recommended pump
specification-flux: refer to Technical Parameter, Max. lift ≥10m
③ When the heat pump is running, there will be condensation water discharged from the
bottom, please pay attention to it. Please insert the drainage tube(accessory) into the
hole and clip it well, then connect a pipe to drain off the condensation water.
2.2.3. Wiring & protecting devices and cable specification
① Connect to appropriate power supply, the voltage should comply with the rated voltage
of the products.
② Well earth the heat pump.
③ Wiring must be connected by a professional technician according to the circuit
diagram.
④ Set breaker or fuse according to the local code (leakage operating current ≤ 30mA).
⑤ The layout of power cable and signal cable should be orderly and not affecting each
other.
Name
A
315
VESIN10
315
VESIN13
VESIN17 395
395
VESIN28
505
B C D
590 312 340
590 312 340
590 392 420
720 391 420
790 496 530
- 9 -
E F G
961 280 74
961 340 74
961 390 74
1092 620 74
1161 650 74
For users
H
658
658
658
958
958