Dry-Run Protection; Automatic Switching Off Of The System; System Drying (Only For Air System And Whirl+Air System); Disinfection - HOESCH Whirlsystem Laola II Instructions De Montage Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
10

Dry-run protection

Your Laola II bathtub with whirlpool system is equiped with "dry run" protection. Water pump and disinfection can be
active if the proper water level is achieved. "Dry run" protection prevents system working with empty bathtub or if the
water level is too low.
11

Automatic switching off of the system

The operational time of the system is limited to 20 minutes. After 20 minutes, regardless of the buttons switched on,
the system switches off automatically. By pressing button 1 and/or 5 you can switch the system on again.
GB
12
Ozonation (only for air system and whirl+air system)
Ozonization is automatically activated when the blower is turned on.
13

System drying (only for air system and whirl+air system)

The system drying function is switched on automatically approx. 10 minutes after emptying the bathtub. After switching
on it works in total for about 2 minutes, during which the blower works for the fi rst 30 seconds with medium power, and
for the next 90 seconds it works with full power.
During time measurement to the beginning of drying and during drying process, buttons 1, 2 and 4 are active.
2 + 4 – simultaneous pressing of the buttons immediately starts the pump despite the fact that time to the beginning of drying
has not elapsed.
1 – pressing the button during operation turns the pump off. Pressing the button during time measurement to drying cancels
the
operation.
14

Disinfection

Regular disinfection ensures optimal hygiene. It is recommended to start the disinfection once a month or every
2-3 bathing.
Notice: In case the bathtub with whirlpool system was not used for a long time, it is necessary to start
disinfection before the system is used again.
The proper water level is necessary to start the disinfection - eventually the water level has to be up to the level
to start the lighting.
We do not take the resposibility of damages or risks made by using improper agents.
After leaving the bathtub pour the disinfecting agent into it (follow the producer's instructions!). We recommend
using the disinfecting agent with the article No. 6923 or 133607.
Suggested amounts: 100 ml of the disinfecting agent for 100 L of the bathtub capacity.
Producers tips should be observed.
Manual disinfection should be start by the pushing the button of air or water system (depends on the system
which bathtub is equipped in).
22
Minimum height of water level
Minimum height
of water level

Publicité

Table des Matières
loading

Table des Matières