emerio MIS-122958.2 Mode D'emploi page 5

MIS-122958.2
PARTS DESCRIPTION & ASSEMBLY

Before use, please check the four casters (1) are already installed onto the standing base (2) firmly.

Insert the motor unit (3) into the main body (4). Fix with the screw (5) on the back.

Insert the main body into the standing base. Fix with the fastening screw (6).

Loosen the fastening screw (7) on the motor shaft (8). Attach the rear fan guard (9) onto the motor shaft.
Make sure the guard fits properly with the handle (10) on the top. Tighten back the fastening screw.

Remove the protection sleeve from the motor shaft. Insert the fan blade (11) onto the motor shaft. Tighten
the blade screw (12) to secure the fan blade.

Loosen the three screws (13) on the back side of the front lid (14). Attach the front lid (14) onto the front fan
guard (15). Make sure the hose (19) which is connected to the front lid (14) points toward the direction of
the clasp (17). Fix the front lid (14) and the front fan guard (15) together by tightening back the three screws
(13).

Attach the clamping ring (16) onto the front fan guard (15). Hook the front fan guard onto the rear fan guard.
Fix with the clasp (17) and then secure with the screw (18).

Insert the hose (19) into the hole on the main body.

Remote control (20) can be stored on the back of the body.
- 4 -
EN