Compatibility; Binding Procedure; Wiring Diagram - XciteRC RX3I Mode D'emploi

Compatibility

The receiver only works with transmitters of Xcite RC.
EN
Transmitter
XRC-6s
XRC-4s
XRC-6Si
XRC-3i FHSS
XRC-3i LCD FHSS Prospec
Modul XRC-M6i

Binding procedure

So that the receiver always works with only one transmitter, the receiver must be bound to the transmitter
before use.
Binding:
Switch on the transmitter, reduce throttle to its lowest position and make sure the alarm is off when powering
on the receiver/aircraft. Press the bind button (if applicable) until the green light turns, solid, signaling binding
success.
Caution:
While binding, place the transmitter and receiver antennas in close proximity if possible; make sure that there
are no similar devices on bind mode within approximately 10 meters. If the light flashes after the binding
procedure is complete, retry the binding procedure again until the light turns solid.

Wiring diagram

RX5I
14
XciteRC-Transmitter-Compatibility
Order-number
50500000
50300000
50501000
50200000
50201000
50600000
Receiver
Car RX3I RX7I
51000004 51000002
x
x
x
x
x
x x
Battery
3. Channel
2. Channel
1. Channel
51000004/0002/0003 Empfänger RX3I, RX5I, RX7I
Getting started