Connections - Panasonic TX-55C320E Mode D'emploi

Connections

Connector Type
Scart
Connection
(back)
YPBPR
YPbPr Video
Connection
(back)
/ Video
HDMI
Connection
(bottom&side)
VGA
Connection
(bottom)
AUDIO IN
PC/YPbPr/
Back AV
Audio
Connection
(back)
SPDIF
SPDIF
(Optical Out)
Connection
(bottom)
BACK AV
Back AV
(Audio/Video)
Connection
R
(back)
/ Video
L
HEADPHONE
Headphone
Connection
(side)
USB
Connection
(back&side)
CI
Connection
(side)
LAN
Ethernet
Connection
(bottom)
Subwoofer
Connection
(back)
Cables
YPbPr Connection Cable
YPbPr/PC Audio Cable
Audio Video Cable
LAN / Ethernet Cable
English - 10 -
Device NOTE: When connecting a
device via the YPbPr or Back
AV inputs, you must use the
connection cables to enable
connection. See the illustrations
on the left side. | To enable
PC/YPbPr audio, you will need
to use the Back Audio inputs
with a YPbPr/PC audio cable
for audio connection. | If an
external device is connected via
the SCART socket, the TV will
automatically switch to AV mode.|
When receiving DTV channels
(Mpeg4 H.264) or while in Media
Player mode, output will not be
available via the scart socket. |
When using the wall mounting
kit (available from third party
in the market, if not supplied),
we recommend that you plug all
your cables into the back of the
TV before mounting on the wall.
| Insert or remove the CI module
only when the TV is SWITCHED
OFF. You should refer to the
module instruction manual for
details of the settings. | The/Each
USB input of your TV supports
devices up to 500mA. Connecting
devices that have current value
above 500mA may damage your
TV. | By connecting an HDMI cable
to your TV, you have to use only a
shielded HDMI cable to guarantee
a sufficient immunity against
parasitic frequency radiation.
If you want to connect a
device to the TV, make
sure that both the TV
and the device are turned off
before making any connection.
After the connection is done, you
can turn on the units and use
them.