Shutdown And Startup Problems - Fujitsu LifeBook T4410 Tablet PC Guide D'utilisation

Problem

Shutdown and Startup Problems

The Suspend/Resume 
button does not work.
The system powers up,
and displays power on
information, but fails to
load the operating system.
An error message is dis-
played on the screen dur-
ing the Tablet PC (boot)
sequence.
Your Tablet PC appears to
change setup parameters
when you start it.
Your system display won't
turn on when the system is
turned on or has resumed.
Possible Cause
Suspend/Resume 
button is disabled.
There may be application
software. conflict
The boot sequence settings
of the setup utility are not
compatible with your configu-
ration.
You have a secured system
requiring a password to load
your operating system.
Internal hard drive was 
not detected.
Power On Self Test (POST)
has detected a problem.
BIOS setup changes were not
saved when made and you
exited the setup utility.
The BIOS CMOS hold-up bat-
tery has failed.
You have installed the Life-
Book/Security Application
panel.
114 - Troubleshooting
Possible Solutions
Enable the button by going to the Control Panel -> Power
Options Properties and clicking on the Advanced tab. In the
Power buttons area, select the "Change what the power but-
ton does" option.
Close all applications and try the button again.
Set the operating source by pressing the [ESC] key while the
Fujitsu logo is on screen or use the [F2] key and enter the
setup utility and adjust the source settings from the Boot
menu. See "BIOS Setup Utility" on page 72.
Make sure you have the right password. Enter the setup util-
ity and verify the Security settings and modify them as
accordingly. See "BIOS Setup Utility" on page 72.
Use the BIOS setup utility or Primary Master submenu,
located within the Main menu, to try to auto detect the inter-
nal hard drive.
See the Power On Self Test (POST) messages to determine
the meaning and severity of the problem. Not all messages
are errors; some are simply status indicators. See "Power On
Self Test Messages" on page 118.
Make sure you select Save Changes And Exit when exiting
the BIOS setup utility.
Contact your support representative for repairs. This is not a
user serviceable part but has a normal life of 3 to 5 years.
Check the Status Indicator Panel for presence of the Security
icon. If it is visible, enter your password See "Status Indicator
Panel" on page 30.