DURAVIT C14230 0000 Notice De Montage Et D'utilisation page 5

These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a
qualified plumber.
Explanation of the key words and symbols
NOTICE
Addresses practices not related to
physical injury.
Link to the mounting instructions
in this section
Prompt for inspection
(e.g. for scratches)
Prompt to wear gloves
Optional settings
Technical data
Operating pressure
Recommended
Test pressure
1 MPa = 10 bar = 145 PSI
Hot water temperature
MAL_57186/20.10.2
max. 0.5 MPa
0.3 MPa
0.5 MPa
max. 60 °C
Safety instructions
Cut and crushing injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations
and any country-specific standards at all
times.
> Equalise pressure differences between cold
and hot water connections.
> Observe the manufacturer's instructions for
installation with continuous flow heaters.
Mounting instructions
1
Flushing and siliconising (diagram 01)
NOTICE
Tap unit malfunction due to dirty pipes
> Flush the pipes according to the applicable
standards before mounting the tap unit.
Water damage
> Enclose pipes with silicone that does not
contain acetic acid.
5