Blatchford Multiflex Ankle 30 mm Instructions D'utilisation page 6

6 Bench Alignment
½
*
Allow for users
own footwear
Build
Line
½
6.1 Additional Components
Follow the alignment instructions that are
supplied with any additional components.
6.2 Static Alignment
With the flexion accommodated the build
line should pass through the center of the
socket in the sagittal (A–P) plane and through
the center of Multiflex Ankle. Adjust the heel
height at the serrated interface.
Make sure that, when the user is standing, the
heel and the toe are evenly loaded and the
foot is in full contact with the floor.
6.3 Dynamic Alignment
Coronal Plane
Minimise M–L thrust by adjusting the relative
positions of the socket and the foot.
Sagittal Plane
Make sure that the user transitions smoothly
from heel strike to toe-off.
Check that the serrations are engaged
before tightening the foot bolt.
Incorrectly engaged serrations can cause
noise, looseness, and the eventual failure

of the foot bolt.

6 938224/5-0819