Perel Turbo CH0004 Mode D'emploi page 6

6. Installation
Install the feet on the bottom of the appliance. Fix each foot with two screws.
Install vertically on a flat, dry, stable and non-slippery surface.
7. Operation
7.1 General Operation
Insert the power plug into the mains.
Turn the thermostat knob fully to the right.
Switch on the heater by selecting the power (each one of the two knobs or both).
To distribute the heat more quickly, switch on the fan with the fan button. You can also use the
fan without heating to blow cold air.
When the room has reached the desired temperature, turn the thermostat knob to the left until
the heater switches off. The temperature is now set and the heater will automatically switch
on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
7.2 Overheating Protection
This heater is equipped with an overheating protection, which will automatically switch off the
heater in case of overheating. If this occurs, please unplug from the mains and allow cooling
for 30 minutes before re-connecting and switching on again.
To avoid overheating, check that the appliance is sufficiently ventilated and that the air intakes
are unobstructed. Please contact your local dealer if the heater keeps switching off.
8. Cleaning and Maintenance
Before cleaning, switch of the appliance, disconnect from the mains and allow to cool
completely.
Never immerse the appliance in water or any other liquid. Protect it from splashes and spraying
liquid.
Occasionally wipe with a damp cloth to keep it looking new. Do not use harsh chemicals,
cleaning solvents or strong detergents.
V. 03 – 15/06/2018
CH0004
6 ©Velleman nv