Hama TS35C Mode D'emploi page 8

Note
• Initial setup takes approximately 5 minutes.
• During the connection attempt, the radio symbol and the LED
indicator (1) on the measuring station will flash.
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
• The measured value is automatically updated by the base device
about every 60–64 seconds.
6.2. Selecting the channel/Other measuring stations
Note
• Ensure that the base station and measuring station are set to
the same channel. Suitable base stations can be found at www.
hama.com
• The transmission channel on the supplied measuring station can be
changed/set (CH1, CH2, CH3).
• The measuring station is suitable for the following base stations:
00113984, 00113985, 00113986, 00186309
6.3. Low battery charge
Once the battery symbol
the capacity of the batteries in the measuring station is very low. Replace
the batteries immediately.
appears on the display of the base station,
7